|
It is currently Mon 25. Nov 2024 0:45:50
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
Blademaster
|
 Posted: Tue 02. May 2017 8:24:07 |
|
Joined: Tue 02. May 2017 8:08:46
Posts: 8
|
|
Hi,
I'm using a Spirit Pro (FW 2.31) in a HD 750 helicopter.
By hoovering the helicopter and controlling short elevator inputs, the helicopter
is a little bit swinging before stopping. By controling short aileron inputs,
the stopping behavior is very good.
During the flight all is fine, the problem is only by hoovering and short elevator inputs.
Is there a parameter to optimize this behavior ?
Thanks and best regrds,
Dirk
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Tue 02. May 2017 8:27:47 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hi,
increase Advanced/Elevator Filter to 3, maybe 4 if needed. Then it should be fine.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Blademaster
|
Posted: Tue 02. May 2017 8:32:16 |
|
Joined: Tue 02. May 2017 8:08:46
Posts: 8
|
|
Thanks, I'll try.
Best regards,
Dirk
|
|
| Top |
|
|
|
Blademaster
|
Posted: Mon 08. May 2017 11:01:16 |
|
Joined: Tue 02. May 2017 8:08:46
Posts: 8
|
|
Setting the Elevator Filter from 2 to 3 works fine.
Thanks and best regards,
Dirk
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 89 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
