| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Swinging after short elevator inputs https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1957 |
Page 1 of 1 |
| Author: | Blademaster [ Tue 02. May 2017 8:24:07 ] |
| Post subject: | Swinging after short elevator inputs |
Hi, I'm using a Spirit Pro (FW 2.31) in a HD 750 helicopter. By hoovering the helicopter and controlling short elevator inputs, the helicopter is a little bit swinging before stopping. By controling short aileron inputs, the stopping behavior is very good. During the flight all is fine, the problem is only by hoovering and short elevator inputs. Is there a parameter to optimize this behavior ? Thanks and best regrds, Dirk |
|
| Author: | ZeXx86 [ Tue 02. May 2017 8:27:47 ] |
| Post subject: | Re: Swinging after short elevator inputs |
Hi, increase Advanced/Elevator Filter to 3, maybe 4 if needed. Then it should be fine. |
|
| Author: | Blademaster [ Tue 02. May 2017 8:32:16 ] |
| Post subject: | Re: Swinging after short elevator inputs |
Thanks, I'll try. Best regards, Dirk |
|
| Author: | Blademaster [ Mon 08. May 2017 11:01:16 ] |
| Post subject: | Re: Swinging after short elevator inputs |
Setting the Elevator Filter from 2 to 3 works fine. Thanks and best regards, Dirk |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|