|
It is currently Sun 24. Nov 2024 12:36:25
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
Bjoern_ve
|
 Posted: Sun 30. Apr 2017 16:07:54 |
|
Joined: Thu 15. Jan 2015 20:29:23
Posts: 12
|
|
HI.
After an update from the 1.xx to the current firmware, I have my LOGO 500 problems with the rear. It oscillates at a speed of approx. 1500rpm. At higher speeds I could not determine.
Is there an explanation?
Setup:
Kontronik Jive100LV
Swashplate: 3x Savöx 1257TG
Tail: Savöx 1290mg
Motor: Scorpion 4020 1100KV
Björn
_________________
Gaui X3, Gaui X7
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Sun 30. Apr 2017 22:02:04 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hi,
there are big difference between 1.x and 2.x firmwares. So it will require also slightly different setup. Especially regarding the Gyro Gain, Rudder Delay and Pirouette Consistency. Also Subtrims are different.
So if you are using same values, it might be needed to update them.
You can send me your settings so I can check it.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Bjoern_ve
|
Posted: Mon 01. May 2017 9:54:08 |
|
Joined: Thu 15. Jan 2015 20:29:23
Posts: 12
|
|
Hi,
here are my settings files.
Björn
_________________
Gaui X3, Gaui X7
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 80 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
