| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| No pitch; and wrong direction of FBL in case of move https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1935 |
Page 1 of 1 |
| Author: | scvflyer [ Wed 19. Apr 2017 13:17:07 ] |
| Post subject: | No pitch; and wrong direction of FBL in case of move |
Hi serviceteam, setting my spirit system (standard) after update - setting channels seams to be fine. Pitch movement is shown at general channel setting as well. But if i try to use pitch under normal circumstances - it doesn't work. Second - setting direction of each channel has be done and works properly but - if Helicopter will be moved to one site (aileron) Spirit systems moves to same direction - but has to move against this direction Any idea? thanks in advance and br siggi |
|
| Author: | Adrian [ Wed 19. Apr 2017 19:55:37 ] |
| Post subject: | Re: No pitch; and wrong direction of FBL in case of move |
Direction: This can have different reasons, usual if followed installation wizard, this should work. Causes, Spirit pointing to wrong flight direction or servo plugged in on wrong ports in Spirit. |
|
| Author: | scvflyer [ Wed 19. Apr 2017 22:28:47 ] |
| Post subject: | Re: No pitch; and wrong direction of FBL in case of move |
Hi Adrian, I fixed one issue - dircection of contra movement while moving heli has been fixed - I set reverse movement in spirit and normal at TX. last issue - no pitch movement. Pitch traveling is shown at diagnostic tabs from spirit - therfor signal must be known at spirit Aileron, elevator, rudder, rescue mode works fine. Thanks supporting me br siggi |
|
| Author: | jgiannakas [ Thu 20. Apr 2017 7:03:18 ] |
| Post subject: | No pitch; and wrong direction of FBL in case of move |
If you're not getting any pitch (collective) you have rescue enabled & active. |
|
| Author: | scvflyer [ Fri 21. Apr 2017 11:55:42 ] |
| Post subject: | Re: No pitch; and wrong direction of FBL in case of move |
Hi jgiannakas, you are right - I have a mixer at TX and this doesn't work properly (after updating TX Software). thanks and br Siggi |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|