| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Rudder Limit Reached https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1892 |
Page 1 of 1 |
| Author: | Ortie [ Fri 17. Mar 2017 19:49:51 ] |
| Post subject: | Rudder Limit Reached |
Just doing the configuration of my Goblin 570 with the SPIRIT. From the mechanical point of view it seems all is okay. But I don't know why I get always the message "Rudder Limit Reached" in the Log View. When I installed the SPIRIT on my Goblin 500 I didn't get the message at any time and it is flying well. What I'm doing wrong? The tail servo is the SAVOX 1290MG and I'm using the Spirit Governor with Hobbywing Platinum 100A V3. I'm afraid to start my first flight with such message.... |
|
| Author: | ZeXx86 [ Sat 18. Mar 2017 11:24:04 ] |
| Post subject: | Re: Rudder Limit Reached |
Hello, if you are doing configuration and not flying, then this message is only telling you, that you have moved the model or rudder stick and the tail slider reached configured limit. There is nothing wrong with it and can happen with completely each helicopter when you will do the same. This message is meaningfull during flight, but as you have said, it was not flying yet. You can read about this event in our manual in the Log Viewer section: http://manual.spirit-system.com/index.p ... NOSTIC_TAB |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|