Hello
What is the meaning of the red button in sensor testing?
Does it have to be red or green when Gov is active?
Thanks
| Attachments: |
|
1Spirit.jpg [ 134.13 KiB | Viewed 933 times ] |
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Governor- RPM Sensor Testing https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1880 |
Page 1 of 3 |
| Author: | stipsi [ Fri 10. Mar 2017 17:39:10 ] | ||
| Post subject: | Governor- RPM Sensor Testing | ||
Hello What is the meaning of the red button in sensor testing? Does it have to be red or green when Gov is active? Thanks
|
|||
| Author: | Dn_Spirit [ Mon 13. Mar 2017 11:23:48 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
Hello, this button is normally red, but when RPM sensor is connected and signal is High then it will change color. When RPM signal (voltage level) is low then color is changed to white (Status - Inactive) Depending on the signal, you might see changes even during motor rotation by hand. |
|
| Author: | stipsi [ Mon 13. Mar 2017 20:13:30 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
Ok, thanks. |
|
| Author: | jgiannakas [ Mon 13. Mar 2017 20:15:33 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
So I tried this on the goblin 500 with HW 100a v3 rpm out and while the RPM reads properly the indicator stays grey! Software bug or do I have a problem? |
|
| Author: | ZeXx86 [ Mon 13. Mar 2017 20:30:47 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
Some sensors are outputting the high/low level as a tiny spikes, so the software may be not able to check fast enough that the signal was high/low. Probably we will update it little bit so it will be well visible in any case. |
|
| Author: | stipsi [ Mon 13. Mar 2017 21:18:33 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
Oh that would be fine, thanks! |
|
| Author: | FrankFuss [ Wed 15. Mar 2017 16:23:02 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
ZeXx86 wrote: Some sensors are outputting the high/low level as a tiny spikes, so the software may be not able to check fast enough that the signal was high/low. Probably we will update it little bit so it will be well visible in any case. Is the sampling rate the same on the Spirit and Spirit Pro? |
|
| Author: | ZeXx86 [ Wed 15. Mar 2017 18:27:06 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
Yes, completely same. |
|
| Author: | sheva99 [ Wed 29. Mar 2017 14:59:01 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
When are you going to fix this problem? |
|
| Author: | ZeXx86 [ Wed 29. Mar 2017 17:25:39 ] |
| Post subject: | Re: Governor- RPM Sensor Testing |
Hello. With the upcoming update. |
|
| Page 1 of 3 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|