Spirit System https://www.spirit-system.com/phpBB3/ |
|
[SOLVED] New to Spirit FBL and the first question https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1632 |
Page 1 of 1 |
Author: | thgeisel [ Fri 09. Sep 2016 18:47:37 ] |
Post subject: | [SOLVED] New to Spirit FBL and the first question |
I got my second spirit pro today and put it in a thunder tiger raptor E550 Everything is working fine, the only problem is that the tail is moving up and down during flight . Not much and I can fly like this, but it would be nice if there is a parameter in spirit to stop it. |
Author: | Dawiev [ Fri 09. Sep 2016 20:02:26 ] |
Post subject: | Re: New to Spirit FBL and the first question |
Check the Tuning Guide in the Sticky section for elevator procedures |
Author: | ZeXx86 [ Sat 10. Sep 2016 14:55:40 ] |
Post subject: | Re: New to Spirit FBL and the first question |
Hi, is the helicopter after crash or it is new one? If it is after crash, then it can be caused by a bent main shaft. If new, then it could be too tight bolts in the blade holders - in this case blades can't center properly so it is not balanced. Making it more loose it will solve the problem. |
Author: | thgeisel [ Sat 10. Sep 2016 15:43:26 ] |
Post subject: | Re: New to Spirit FBL and the first question |
Thank you for your help. I will try the things you suggested and look if it is getting better. The thing is , the heli was flying till thursday with a vbar without that behavior , on friday I recieved the spirit pro and put it into the heli . Maybe the spirit is more sensitiv. |
Author: | ZeXx86 [ Sat 10. Sep 2016 22:08:04 ] |
Post subject: | Re: New to Spirit FBL and the first question |
If it worked well with Vbar, then it can work well with Spirit too and can be tuned with parameters. The parameters that could affect this are: - high Sensor/Cyclic Gain - high Advanced/Geometry 6° (please verify the value) - high Advanced/Elevator Filter - inprecise Subtrim settings If you are flying with low RPM then it might need a special tuning. |
Author: | velocity90 [ Sun 11. Sep 2016 7:28:26 ] |
Post subject: | Re: New to Spirit FBL and the first question |
Did you select a 140 degrees swashplate? Just a thought . |
Author: | thgeisel [ Sun 11. Sep 2016 8:23:37 ] |
Post subject: | Re: New to Spirit FBL and the first question |
Yes, I selected the 140° Swashplate. And I did some small corrections in the mechanical setup and the geometrie 6° and now the problem is solved. Thank you very much for all your help |
Page 1 of 1 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |