Spirit System
https://www.spirit-system.com/phpBB3/

3 blades rotor heads
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1464		 Page 1 of 1
Author:  JamesO [ Tue 31. May 2016 21:31:55 ]
Post subject:  3 blades rotor heads
Can you tell me if the Spirit controller supports multi-blade rotor head? If yes, how do I change the swashplate timing.

thanks
Author:  Gtamas [ Tue 31. May 2016 21:49:51 ]
Post subject:  Re: 3 blades rotor heads
Yes it does.

In the pc software, advanced tab, expert settings, and there is the "cyclic phase" what you are looking for.
Author:  JamesO [ Tue 31. May 2016 22:53:42 ]
Post subject:  Re: 3 blades rotor heads
thanks, I am new to the multi-blade rotor system, can you tell me what is the proper phase to set a three blade rotor?

thanks
Author:  Gtamas [ Tue 31. May 2016 23:28:02 ]
Post subject:  Re: 3 blades rotor heads
Depends on the rotor head. Mostly 3 blade systems uses the sam 90 degree as the 2 blades systems, so you dont have to do anything with this setting. What head exactly are you talking about?
Author:  JamesO [ Wed 01. Jun 2016 0:47:08 ]
Post subject:  Re: 3 blades rotor heads
Gaui X7 three blades.. thanks
Author:  MarkusD [ Fri 03. Jun 2016 18:25:43 ]
Post subject:  Re: 3 blades rotor heads
You Need to adjust it until the blade which is over the boom does not move when using cyclic forward- this value may vary as mentioned depending on head geometry

BR,

Markus
Author:  Gtamas [ Fri 03. Jun 2016 19:44:22 ]
Post subject:  Re: 3 blades rotor heads
I think gaui x7 3 blade aldo uses 90 phasing so you dont need to do any specific with it.
Author:  MarkusD [ Sat 04. Jun 2016 1:28:07 ]
Post subject:  Re: 3 blades rotor heads
Gtamas wrote:
I think gaui x7 3 blade aldo uses 90 phasing so you dont need to do any specific with it.


Could well be the case....but i would always check as i said....don't think that anybody wants to fly with strange settings
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/