|
It is currently Mon 25. Nov 2024 7:52:02
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Romis
|
 Posted: Thu 14. Apr 2016 12:47:45 |
|
Joined: Wed 27. May 2015 13:04:44
Posts: 18
|
|
I have a Spirit (classic) connected by SBUS to Orange RX with telemetry. Throttle cable goes from ESC to RX, everything works fine, currently I`m using ESC governor but I want to try Spirit governor and connect Orange RPM sensor to the telemetry port of RX to see RPM. Question is - do I have to connect the RPM sensor directly to Spirit (as per manual) if I want to activate governor in Spirit? OR will the SBUS line give RPM data to Spirit in case I connect sensor to the telemetry port of RX (this should be preferable in order to use telemetry RPM).
Wiring: ESC (YEP)=>throttle signal=>RX Orange=>SBUS line=>Spirit FBL unit
OR - if I connect RPM cable to Spirit unit will RX receive RPM signal by SBUS from Spirit?
Last edited by Romis on Thu 14. Apr 2016 12:59:51, edited 1 time in total.
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Thu 14. Apr 2016 12:56:30 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Unfortunately this is not possible due to technical difficulties.
Telemetry data are transmitted too slow to be useable for governor.
So RPM sensor must be always connected to the unit directly.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 18 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
