| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Version 2 rescue https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=1231 |
Page 1 of 1 |
| Author: | agh321 [ Sat 27. Feb 2016 18:39:47 ] |
| Post subject: | Version 2 rescue |
Hi just downloaded version2 and re set my trex 700n in but what ever I do the rescue goes into negative pitch in normal and acro. trying to adjust and can go from -8 to 0 deg but no + pitch What have I missed |
|
| Author: | ZeXx86 [ Sat 27. Feb 2016 18:46:04 ] |
| Post subject: | Re: Version 2 rescue |
Hi, it looks like the basic setup was not done properly. First from all please make sure that your sticks movement correspond to the Diagnostic tab, especially all the directions. So when you move your collective pitch stick to the positive, you will see that the bar is positive as well. |
|
| Author: | Alyon187 [ Sat 27. Feb 2016 19:17:24 ] |
| Post subject: | Re: Version 2 rescue |
Also make sure your servo connections are the same as what the swashplate shows. Unlike the previous version, servos 1 & 3 matter which slot they go into. That and that you select the correct swashplate orientation and set your servo reverses in your radio back to their default position. W 2.0 any reverses should be done in the software, not in your tx. |
|
| Author: | agh321 [ Sat 27. Feb 2016 19:33:29 ] |
| Post subject: | Re: Version 2 rescue |
Alyon187 wrote: Also make sure your servo connections are the same as what the swashplate shows. Unlike the previous version, servos 1 & 3 matter which slot they go into. That and that you select the correct swashplate orientation and set your servo reverses in your radio back to their default position. W 2.0 any reverses should be done in the software, not in your tx. Ok I'll have another go I do remember reversing the pitch and elevator servos in my dx9 to get the right direction Thanks for the help |
|
| Author: | ZeXx86 [ Sat 27. Feb 2016 19:41:27 ] |
| Post subject: | Re: Version 2 rescue |
You have to get correct direction in the Diagnostic tab first. Then you should reverse channels anymore. This is different between older versions. |
|
| Author: | agh321 [ Sat 27. Feb 2016 20:39:37 ] |
| Post subject: | Re: Version 2 rescue |
ZeXx86 wrote: You have to get correct direction in the Diagnostic tab first. Then you should reverse channels anymore. This is different between older versions. Ok thanks I'll re set it up again tomorrow Ok all done and rescue is fine now Thanks for the help Apart from the swash servo direction it does seem to be very straight forward now With the wizard doing most of the set up for you |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|