OK going to try and explain this:

downloaded latest firmware, reset to factory default, use the wizard to program goblin 500, everything goes well all movements are good. Now I need to program rescue and stabilization, I have 3 position switch working on channel 7 and shows movement in diagnostics. I have switch at position 1 and activate Bank 0 with rescue, then I move switch to middle position and activate bank 1 with the same rescue, then I move the switch to position 3 and activate bank 2 with stabilization.

all have been saved, when I have the radio switch in position 1 or 2(middle ) for rescue mode (bank 0 and 1) I have no pitch movement in bank 2 (stabilization) I have pitch movement for the life of me and my buddy we can not figure it out.

any help on what we are doing wrong would be appreciated

Angus

figured it out, gyro was reversed