That's not good. It seems as problem with logging now.

Check this please: http://spirit-system.com/dl/fw/test/spi ... -test3.bin

_________________
Spirit System developer

Still having the same issue with the Tx turned on. Very weird. With the Tx off it does not happen and if it goes crazy and I turn off the Tx while it is going crazy, it gives it a positive pitch and the tail twitches very very fast but not large movements. Instead of the big fast twitches from before, not it just twitches a very little amount but very quickly.

All is good once I reset the unit.

Thanks. Does it happen with version test3 as well? Do you see any warning about lost signal in the log after this event?

_________________
Spirit System developer

Not sure,

Let me test...

Unfortunately it still has the issue.

The first restart after flashing the firmware I could not get it to happen. I turned it off and back on then switched banks.

When I switched to bank one I changed 1 parameter (stick dead band from 9 to 8) and changed back to bank 0. When asked to save I clicked save and then it started twitching like crazy.

Very weird. Thank you for the help/support!

OK, thanks.
At least I know from these tests where the problem is not present.

Another one: http://spirit-system.com/dl/fw/test/spi ... -test4.bin

_________________
Spirit System developer

Ok cool,

I will test when I get back home. Went and flew a few packs and the gym.

Ok, tested Version 4 and much better!

I can not seem to get it to go crazy after saving or opening any logs.

The only time I can get a weird behavior now is if I have the Spirit plugged into the software and the Tx is on. When I turn the Tx off the tail servo will twitch very fast until it has regained signal from the Tx.

This only happens if I am in the software. If I turn the Tx off without the Spirit connected to the computer it does not do this.

Other than that, whatever you change fixed the problem!

Thank you!

Great!
I think transmitter is sending some weird data (Maybe Failsafe?) but I think it could be fixed too.
I guess you can see extreme value in the diagnostics tab when this happen?

_________________
Spirit System developer

Yes, Rx signal lost of corse. I didn't save it but I will next time to send to you.

Thanks for all the support!