thanks all for all hints, replies inline
> if running the governor, the gain could be too high or too low for response gain.
using castle internal governor "set rpm)
> Your tail thrust bearings could be worn out.
all bearing are new
> The tail servo could be going bad.
can be ... will verify
> How much collective pitch are you running?
+-12°
> What is piro consistency set to?
> I would start off around 155 and only turn up main tail gain as much as possible first.
> If it's already low or default then check the things above.[/quote]
is the wizard default for trex 600 - 165
HeliMLM wrote:
@TO: what frequency are you running the tail servo at? (max. = 250Hz for SB2272MG following many sources, other saying 333Hz) btw: did you set Tail Revomix?
is it getting very warm? did you do any test on your tail servo? just put a little bit of load on it by holding tail pushrod with 2 fingers (not too tight) and check if it is starting to loose power more than to be expected (it is strong). does it get very warm during the test?
i had this servo in a Logo 690... first it was easy to setup, tail was good to very good. then i noticed it being really hot after flight, next 2-3 flights some tail blowouts i thought i just pushed it too hard, then it failed mid flight. btw: i was @ 333Hz.
from specifications they say 333Hz
will try at 200Hz ( 250Hz is not available in spirit settings )
https://www.savoxusa.com/products/savsb ... al-details
