|
It is currently Sun 24. Nov 2024 10:39:11
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
Hermor
|
 Posted: Wed 29. Jul 2020 7:26:16 |
|
Joined: Fri 02. Aug 2019 12:35:43
Posts: 21
|
|
I have a problem with my tail setup when stab. scale is activated.
I set up endpoints in limits tab but after switching to stab scale the tail limits left and right changes to probably 50% is this normal behavior?
Verstuurd vanaf mijn SM-A520F met Tapatalk
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Wed 29. Jul 2020 7:41:20 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
This is because your Gyro Gain is very low in this mode. Please increase the Gain. Then it will be OK.
You can compare Gyro Gain between these modes in the Diagnostic tab. Ideally they should be same.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Hermor
|
Posted: Thu 30. Jul 2020 14:45:15 |
|
Joined: Fri 02. Aug 2019 12:35:43
Posts: 21
|
|
Hello, i tried but i think this is not the case.
I am building a scale heli and set gyro gain bij he testflights by tx. Gain is now the same in every flight mode/ bank. The tail range changes something but not much
gr kees
Verstuurd vanaf mijn SM-A520F met Tapatalk
|
|
| Top |
|
|
|
Hermor
|
Posted: Fri 31. Jul 2020 19:34:55 |
|
Joined: Fri 02. Aug 2019 12:35:43
Posts: 21
|
|
When in the same bank i switch in the setup in the stabi tab from stabilisation normal to scale and changes nothing els the tail slider range changes to max 50% of the range in stab normal..
could anything else be the reason for this behavior?
Verstuurd vanaf mijn SM-A520F met Tapatalk
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: Bing [Bot] and 53 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
