It is currently Sun 24. Nov 2024 22:57:17

All times are UTC + 1 hour





Post new topic Reply to topic  [ 4 posts ] 
  Print view Previous topic | Next topic 
Author Message
PostPosted: Mon 09. Dec 2019 15:38:18 
Offline

Joined: Sun 08. Dec 2019 19:48:46
Posts: 2
I am current setting up a Spirit Pro/Geolink with a DX8 on a TREX600 Nitro. I cannot figure out how to assign all the functions I need with an 8 channel transmitter. Here is my current configuration:
- using all 7 transmitter channels for the basic setup with channel 7 assigned to bank switch
- using transmitter channel 8 to enable/disable Stabi mode with a 2 position switch
- bank 0 setup for Horizon Mode on 3 position switch(position 0) controlling channel 7
- bank 1 setup for Rescue Mode on same 3 position switch(position 1) controlling channel 7
- I want bank 2 to select Return to Home on same 3 position switch(position 2) controlling channel 7
but the Spirit Setting software will not allow me to do this. Since I have used up all my transmitter channels,
how to I select Return to Home without another transmitter channel?

Thanks
Don


Top
 Profile  
 
PostPosted: Mon 09. Dec 2019 17:38:05 
Offline

Joined: Sat 19. Mar 2016 20:32:29
Posts: 96
you could free up channel 5 by putting your tail gyro setting directly in the Spirit unit instead of TX then assign a geolink function to channel 5
Other than that you need new TX


Top
 Profile  
 
PostPosted: Tue 10. Dec 2019 15:25:14 
Offline

Joined: Sun 08. Dec 2019 19:48:46
Posts: 2
Yes, that is what I determined, so I had a Spektrum IX12 and began to re-setup the Spirit Pro
on this transmitter. Well, while setting up everything, the Spirit Settings software hung up and I had
to kill it from my PC and power cycle the Spirit Pro. After powerup, now I cannot get the Spirit Pro to
connect to the Geolink. I also noticed the Spirit Pro serial number is ff-ff-ff-ff-ff-1 which is not what it
used to be. And finally, the Spirit Pro is not performing any gyro corrections when I tilt the heli.
It does talk to the transmitter and the servos move correctly when commanded from the transmitter.
Seems like something happened to the Spirit Pro when I powercycled? I tried just about everything but
no fixes.
I tried reflashing the firmware(2.7.1) which went ok, but it did not correct any of the issues.
What should I do?

Tomas: I sent you several personal emails about this. Can you respond to the them?

Thanks
Don


Top
 Profile  
 
PostPosted: Tue 10. Dec 2019 21:13:53 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
Hello,

reply was sent to your email.
I believe it will be sorted easily.

_________________
Spirit System developer


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: Bing [Bot] and 71 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .