ZeXx86 wrote:
Hello,
please make sure that the travel range in your radio is same.
Try to set 100% Gyro Gain and verify in the Diagnostic tab what value you can see there.
You might just change travel little bit.
100% in transmitter = 100% in diagnostic full green bar
50% in transmitter = 0% in diagnostic green bar in the middle
0% in transmitter = 100% in diagnostic no green bar
51% in transmitter =1% in diagnostic tab
52% in transmitter = 3% in diagnostic tab
53% in transmitter = 5% in diagnostic tab
54 % in transmitter = 7% in diagnostic tab
and so on.
so the endpoints are correct but the individual steps are not, 1 step in transmitter = 2 steps in diagnostic tab
Does it have something to do with that there is only 0-100 in transmitter but there is effectively 200 in spirit? 0 to 100% and 0 to -100%