Hello everyone, I bought a Spirit Pro (here in Italy) and at first connection with my pc, I upgraded it to 2.6.1
I connected an OpentTx via Sbus.
There was a BIG problem : the fbl unit does not see any communication on ch 3.
After 3 days of trials...I tried another sbus tx + rx, same result. Elevator does not move.

I installed 2.6.0 and wow... ch 3 is present now

Bad news is that the unit fries tail servo for error in limit travel (that I've not seen,pointing all my attentions at that malefic dead swashplate.

I suggest you to create a repository for previous version of software, I found the old version by luck ...substitute file download name with ....2.6.0 ending letter name eheh


Now I have to resolve why the trex 450 pro has tail out of control but I have setted up normal stabilisation....

bye!

I have OpenTx using sbus and all my channels work ok on version 2.6.1. Strange that yours isn't!

Sent from my SM-G950F using Tapatalk

Hello,

I am afraid, but there is no change regarding Channel 3 in 2.6.1.
We can retest it immediately, but there are already thousands pilots flying with the same version without any issue.

Could you reflash back to 2.6.1 to see if the problem reappear?

_________________
Spirit System developer

Yes, I have flashed 2.6.1 3 times, with the same results...
I've flashed 1.3 and all was right.
Then I have flashed 2.6.0 and it is ok, but then I have not tried to reflash 2.6.1
I tried Frsky and Flysky tx and rx, strange behaviour...
I can try to reflash 2.6.1

Is your throttle channel assigned in the channel menu?

I'm using a r xsr in sbus mode, working great.

I had similar problems when starting my setup. I found that creating a new model in OpenTX with AETR channel order resolved my problem.