|
It is currently Sun 24. Nov 2024 23:27:57
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 4 posts ] |
|
| Author |
Message |
|
Franky13
|
 Posted: Wed 26. Sep 2018 17:22:49 |
|
Joined: Tue 30. Dec 2014 7:50:36
Posts: 135
|
|
Hi Tomas!
Please explain to me why the 6 degree geometry should be set to 4.5 on TDF.
What is better at 4.5 Geometry, what are the positive effects of the change in TDF?
Or can adjust other parameters to get the same effect?
Thanks for answer!
Greeting Frank
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Thu 27. Sep 2018 8:04:17 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hi,
TDF has not standard geometry and because Geometry 6° is counting with standard geometry it require different configuration for linear servo travel.
If value is too high then you will get unwanted oscillations and problems with elevator.
No, you can't achieve same settings with other parameters.
_________________
Spirit System developer
|
|
| Top |
|
|
|
mb-1953
|
Posted: Thu 27. Sep 2018 12:30:57 |
|
Joined: Tue 03. Mar 2015 15:55:50
Posts: 98
|
|
Would this also apply to the tdr2, which also uses linear linkage.
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Sun 30. Sep 2018 18:01:26 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Yes
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 4 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
