|
It is currently Sun 24. Nov 2024 5:11:13
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
Blademaster
|
 Posted: Tue 25. Jul 2017 9:52:34 |
|
Joined: Tue 02. May 2017 8:08:46
Posts: 8
|
|
Hello,
do I have to order an additional cable to connect a Jeti Rex 3 receiver to the µSpirit ?
Regards,
Dirk
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Wed 26. Jul 2017 11:15:00 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
If you want to use EX Bus, then you will ideally need Jeti integration cable and 2x JST-Servo cables.
If you want to save a weight, you can do your own jeti integration cable just by buying for example JST-RX cable and combining it with supplied JST-RX cable.
1. Plug off orange wire from the JST-RX with a needle.
2. Use any free JST connector or use it from other cable such as JST-RX so that there is no wire in it.
3. Connect orange wire from the step 1 to the free JST connector in the same position as it was. So basically it will look like Jeti integration cable, but with 2 JST connectors and 1 servo connector at the end.
If you do not need integration, you can use supplied JST-RX for UDI or PPM connection. So in this case nothing else than supplied cable is needed.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Blademaster
|
Posted: Wed 26. Jul 2017 12:39:24 |
|
Joined: Tue 02. May 2017 8:08:46
Posts: 8
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 23 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
