|
It is currently Fri 22. Nov 2024 23:56:10
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 10 posts ] |
|
| Author |
Message |
|
pabloK
|
 Posted: Fri 11. Sep 2015 4:34:58 |
|
Joined: Tue 17. Feb 2015 14:42:04
Posts: 56
|
|
Hi
Can you help me setting up this heli? please, see picture attached.
Radio is a FUTABA T14SG with Rx R617FS
I want stabilization and rescue modes also.
Thank you very much
| Attachments: |
IMG_2147.JPG [ 644.24 KiB | Viewed 861 times ]
|
|
|
| Top |
|
 |
|
Coco66
|
Posted: Fri 11. Sep 2015 6:41:43 |
|
Joined: Sun 26. Jul 2015 8:17:50
Posts: 433
Location: Madrid, Spain / Torino, Italy
|
|
That's quite a vague request... what exactly do you need help with?
Did you set up the Spirit according to the manual?
_________________
Oxy 2 ♦ X-Vert ♦ Warp 360 ♦ Blade 450X ♦ Blade 450X Nightflyer ♦ Goblin 500 (RIP) ♦ 2 X mCPX v2 ♦ night fly mQX ♦ LadyMQX ♦ nano QX ♦ nano QX FPV ♦ Inductrix ♦ DX8 G1
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Fri 11. Sep 2015 8:44:31 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Do you want to use Flybar or Flybarless head?
If you want to use flybar, you can do so just be connecting the unit as in flybarless case, you have to perform all the settings normally and then you should just enable Flybar mechanics in the Stabi tab.
Then you are ready to fly.
_________________
Spirit System developer
|
|
| Top |
|
|
|
pabloK
|
Posted: Fri 11. Sep 2015 17:05:48 |
|
Joined: Tue 17. Feb 2015 14:42:04
Posts: 56
|
|
I never setup this kind of servo setup !!!
I did several setup with spirit, but non with flybar and all the servos in the front of the heli!
Can I see any guide for this type of setup?
Thanks a lot
|
|
| Top |
|
|
|
pabloK
|
Posted: Fri 11. Sep 2015 18:39:57 |
|
Joined: Tue 17. Feb 2015 14:42:04
Posts: 56
|
|
For example, what mix did I must use? (CCPM)
what model preset do you recomend?
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Sun 13. Sep 2015 10:22:07 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
If you want to use flybar rotor head,
then you can use preset for Trex 600, but it is not that important.
You should see in the manual of your helicopter what cyclic mixing it uses.
What Hirobo model it is exactly?
_________________
Spirit System developer
|
|
| Top |
|
|
|
pabloK
|
Posted: Mon 14. Sep 2015 16:06:23 |
|
Joined: Tue 17. Feb 2015 14:42:04
Posts: 56
|
|
Bud luck in the field yesterday.
Heli was a Thunder tiger Raptor 30
goes down and touch floor. Please see attached log !
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Tue 15. Sep 2015 16:10:12 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
What happened?
It seems that signal was lost at the beginning for some reason temporarily.
But this thread is for Hirobo, so I suppose that this helicopter is very different.
_________________
Spirit System developer
|
|
| Top |
|
|
|
pabloK
|
Posted: Tue 15. Sep 2015 22:01:31 |
|
Joined: Tue 17. Feb 2015 14:42:04
Posts: 56
|
|
My mistake on the name of the thread, heli was a thunder tiger raptor 30, not a hirobo
Happens that servo connector of rudder and elevator get out because of the vibrations!!
At the begining, heli flyes at least 2 minutes great.
we dont had the oportunity to test bailout
I think you can close this thread
thank you
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Wed 16. Sep 2015 18:19:19 |
|
|
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Oh, thats sad.
Hopefully it will fly again very soon!
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 10 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 51 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
