|
It is currently Fri 22. Nov 2024 23:02:54
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
Dawiev
|
 Posted: Fri 11. Sep 2015 17:33:22 |
|
Joined: Sat 28. Feb 2015 3:08:53
Posts: 139
|
|
Hi, when I activate the governor on the bench, without the engine running, the first part of the throttle behaves as expected. However, once I go past the point where the governor engages, the servo keeps creeping up to 100%. It does not stop at the throttle percentage in the curve (flat curve and the percentage doesn't make a difference).
Is this normal / expected ? Is it simply because the unit is not getting an RPM signal ?
|
|
| Top |
|
 |
|
Scott H
|
Posted: Fri 11. Sep 2015 18:02:21 |
|
Joined: Wed 24. Jun 2015 4:03:28
Posts: 119
|
|
| Top |
|
|
|
ZeXx86
|
Posted: Sun 13. Sep 2015 10:17:25 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Yes, it is because motor is not spinning so it is trying to increase the throttle to get more RPM, but there is no feedback all the time.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 22 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
