|
It is currently Fri 22. Nov 2024 23:42:36
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
Malc1
|
 Posted: Thu 20. Aug 2015 21:41:49 |
|
Joined: Thu 07. May 2015 22:33:47
Posts: 169
|
|
Is says in the manual that servo arm needs to be at 90 degrees to the servo case and at this 0 degrees pitch needs to be on the tail blades.
Is this correct?
Shouldn't the control arm on the tail slider also be at 90 degrees to get an even throw as per the helicopter manual.This, in the case of a TRex 700 puts a few degrees of pitch automatically on the blades.
It doesn't look right with the slider arm off centre.
Is having all arms at 90 degrees and a few degrees of tail pitch OK for setup?
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Fri 21. Aug 2015 7:29:12 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
It will work in both ways - but this setup is mainly dependent on the tail mechanics. In case of Trex we recommend to set it as per manual of the helicopter to achieve the best performance.
Servo arm should be always at 90° in the midpoint - center position.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Malc1
|
Posted: Fri 21. Aug 2015 7:33:06 |
|
Joined: Thu 07. May 2015 22:33:47
Posts: 169
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: Amatrix and 44 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
