|
It is currently Thu 21. Nov 2024 23:37:15
|
View unanswered posts | View active topics
|
Page 1 of 1
|
[ 5 posts ] |
|
Author |
Message |
nzflyer
|
Posted: Tue 06. Oct 2015 9:11:09 |
|
Joined: Sun 04. Oct 2015 9:55:42 Posts: 33 Location: Christchurch New Zealand
|
Hi. Just want to know what setting to adjust to stop my tail blowing out counter clockwise when flying tail in. When i hit rescue or go from negative pitch to full postive the tail blows out from 6 o'clock to 4 o'clock. Any advise would be great cheers.
Sent from my iPad using Tapatalk
|
|
Top |
|
|
ZeXx86
|
Posted: Tue 06. Oct 2015 10:20:55 |
|
|
Site Admin |
Joined: Mon 29. Apr 2013 16:06:44 Posts: 12442
|
Hi,
this problem is mostly caused by: a) tail has too low angle (rudder end-points should be increased if possible) b) head speed is too low so the rudder is not able to mechanically compensate the force. c) Pirouette consistency value or Gyro Gain is too low.
Can you save your settings to the file and attach it there? What is your helicopter and tail servo?
Thanks
_________________ Spirit System developer
|
|
Top |
|
|
nzflyer
|
Posted: Tue 06. Oct 2015 18:21:44 |
|
Joined: Sun 04. Oct 2015 9:55:42 Posts: 33 Location: Christchurch New Zealand
|
The heli is an align 550 dominator. My head speed is 2300 which should be fine. I will increase the gyro gain and redo end points. And see if that helps. I'm pretty sure i can get so more movement in my end points on the tail.
Sent from my iPad using Tapatalk
|
|
Top |
|
|
ZeXx86
|
Posted: Wed 07. Oct 2015 7:13:57 |
|
|
Site Admin |
Joined: Mon 29. Apr 2013 16:06:44 Posts: 12442
|
Ah, you should set the highest possible range if that is not a problem else tail will blow out.
_________________ Spirit System developer
|
|
Top |
|
|
nzflyer
|
Posted: Wed 07. Oct 2015 10:23:44 |
|
Joined: Sun 04. Oct 2015 9:55:42 Posts: 33 Location: Christchurch New Zealand
|
I also found. My one way bearing was playing up. Was locked up. Not sure if that was affecting it. As well. Have adjusted tail.
Sent from my iPad using Tapatalk
|
|
Top |
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
|
Who is online |
|
Users browsing this forum: No registered users and 3 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|