| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| new problem https://www.spirit-system.com/phpBB3/viewtopic.php?f=17&t=4832 |
Page 1 of 1 |
| Author: | broshi [ Tue 17. Aug 2021 1:04:37 ] |
| Post subject: | new problem |
I have 3 units of the earlier spirit. all of them worked well. lately, when I'm trying to use wizard to configure units on other helis, servos are frizing when ariving calibration. Checked cables, software is updated, can't find the problem. ideas? Tnx |
|
| Author: | Habásek [ Tue 17. Aug 2021 6:31:16 ] |
| Post subject: | Re: new problem |
Incorrectly set values for servos - frequency and center in the Servos tab. |
|
| Author: | ZeXx86 [ Thu 19. Aug 2021 8:08:30 ] |
| Post subject: | Re: new problem |
Hello, servos should freeze during Subtrim configuration. You have to set Subtrims and unit should not react to any movement of the model. In next step unit will switch to other mode. |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|