Quote:
GeoLink - New Return to Home feature:
When configuring channel value to 50% for F: GeoLink - Return to Home new feature is engaged. State (4)
Model will return to a Lift Off position.
Lift Off position is automatically programmed any time model is not flying.
Lift Off position is independent from programmed Home spot and is stored in a volatile memory.
Pilot do not have to program any spot and do not have to care about changing field.
Original RTH feature is unchanged and can be utilized complementary.
Do you configure 50% in the digital switch setting in the transmitter?
If so is it possible to configure a 3-pos switch so you do not use the programming mode like
pos 0 is off
pos 1 = 50% lift off RTH
pos 2 = 100% pre-programmed RTH
or is this a wrong assumption?
