| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| SAB Kraken 580 Setup https://www.spirit-system.com/phpBB3/viewtopic.php?f=17&t=4390 |
Page 1 of 1 |
| Author: | TWheli [ Sat 14. Nov 2020 15:48:59 ] | ||
| Post subject: | SAB Kraken 580 Setup | ||
Hi, i share my Setup for the new SAB Kraken 580 maybe it is helpful to someone Setup: Spirit RS Swash 3xGDW BLS590 - 17mm Tail 1x GDW BLS895 - 18mm Xnova 4025-560 Jive Pro 120 12s 3300 SAB 570 TB SAB 95 TB i work nice with the stock blades or MS Rapid 580 blades between 1800 and 2400 rpm Best Regards Timo
|
|||
| Author: | TWheli [ Sat 14. Nov 2020 16:10:41 ] | |||
| Post subject: | Re: SAB Kraken 580 Setup | |||
some pictures
|
||||
| Author: | Luv2fly2 [ Sun 15. Nov 2020 3:43:08 ] |
| Post subject: | Re: SAB Kraken 580 Setup |
Where did you get that antenna holder? |
|
| Author: | TWheli [ Sun 15. Nov 2020 8:34:46 ] |
| Post subject: | Re: SAB Kraken 580 Setup |
Included with the Kraken kit |
|
| Author: | Goody63 [ Wed 04. May 2022 6:30:26 ] |
| Post subject: | Re: SAB Kraken 580 Setup |
Hi there Just wondering if you had any issues getting the cyclic range centred (e.g. 12+ to 12-). I have the same setup (GDW servos etc) but only seem to be able to get a equal range of travel by winding out the Blade Grip linkage rods a fair way (and starting to worry how much thread they have to be secure). When I wind the Servo linkages out a touch to compensate (and reduce the length of the blade grip linkages) then I cant seem to be able to get a even cyclic range (ie end up with something like 10+ to 13-). Any help would be much appreciated. Cheers |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|
