Attachment:
sensor2.jpg [ 628.76 KiB | Viewed 964 times ]
Attachment:
sensor1.jpg [ 552.78 KiB | Viewed 964 times ]
like this?
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| DIY Phasensensor V2 - does it work? https://www.spirit-system.com/phpBB3/viewtopic.php?f=17&t=2845 |
Page 1 of 1 |
| Author: | TomF [ Thu 20. Sep 2018 20:24:12 ] |
| Post subject: | DIY Phasensensor V2 - does it work? |
And how to connect to the Spirit Pro? Regards Tom |
|
| Author: | TomF [ Thu 20. Sep 2018 21:17:50 ] |
| Post subject: | Re: DIY Phasensensor V2 - does it work? |
Attachment: sensor2.jpg [ 628.76 KiB | Viewed 964 times ] Attachment: sensor1.jpg [ 552.78 KiB | Viewed 964 times ] like this? |
|
| Author: | Habásek [ Fri 21. Sep 2018 14:11:54 ] |
| Post subject: | Re: DIY Phasensensor V2 - does it work? |
http://manual.spirit-system.com/index.p ... n#GOVERNOR |
|
| Author: | TomF [ Fri 21. Sep 2018 16:40:04 ] |
| Post subject: | Re: DIY Phasensensor V2 - does it work? |
Ok, not like this: http://manual.spirit-system.com/index.p ... RPM_Sensor but, does it work well? Because this sensor is not listed |
|
| Author: | Shonkonray [ Sat 22. Sep 2018 9:31:25 ] |
| Post subject: | Re: DIY Phasensensor V2 - does it work? |
TomF wrote: Ok, not like this: http://manual.spirit-system.com/index.p ... RPM_Sensor but, does it work well? Because this sensor is not listed For the Pro you can link it like it is shown in your link or like the other link (if i am not mistaken) . If you have your AUX2 free then i would this method, because its the cleanest installation. You would even be able to make a Y-cable and link + and - with a servo lead to power your sensor. Or use Ch0 for power supply. The link from Habásek is showing the only way of wiring with a normal non pro spirit without the use of a y-cable (asuming you dont have a spekturm sat there) So either way will work with rpm signal on PIT and GND and Plus from somewhere of the unit. If the sensor itself will work, i can not tell you. |
|
| Author: | urgno [ Sat 22. Sep 2018 9:35:52 ] |
| Post subject: | Re: DIY Phasensensor V2 - does it work? |
is also a matter of voltage on aux or ch0 you pick the same voltage of all electronics on sat port you pick the regulated 3.3v it all depends on voltage requirements of the sensor |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|