Spirit System
https://www.spirit-system.com/phpBB3/

Goblin 420 Setup
https://www.spirit-system.com/phpBB3/viewtopic.php?f=17&t=2054		 Page 1 of 1
Author:  gabrielwong1991 [ Fri 16. Jun 2017 0:34:01 ]
Post subject:  Goblin 420 Setup
Hi, this is my config file for my new Goblin 420.

I have two problem want to solve with this config file, when coming out of a turn and in fast forward flight, I can hear the tail have a fast wag. This happen after I use the spirit governor, before with HW internal governor there is no wag at all.

Secondly, how can I remove the little kick like (5 degrees) when doing pitch pump?

Funny thing is if I reduce the common gain, the fast wag is gone but then the little kick at pitch pump increases to like 10 degrees. What parameter should I be looking at to have a balance in between?

The tail servo is called GDW DS-595mg, I am running at 5.5Kg.cm/0.03sec/60°@8.4V so I believe I shall run the rudder delay at 0.

Any thoughts?

http://4dsviewer.spirit-system.com/www/ ... ?_fid=n9a2

Attachments:
g420.4ds [255 Bytes]
Downloaded 121 times
Author:  ZeXx86 [ Fri 16. Jun 2017 8:31:30 ]
Post subject:  Re: Goblin 420 Setup
Hi,

with Goblin it is required that the rudder neutral position is configured so that there is a slight angle when rudder servo is at the center position.

When you tick Servos/Subtrim (tuning) all servo arms (including from rudder) should be at the center.
At the same time there must be 3-4° between tail blades.

What can also improve the situation is a shorter servo arm.

Both these changes should improve the rudder performance. Rudder Delay at 0 is fine for this servo.

If you are getting tail wag with governor, than it might be because Governor Response value is too high. You can try to decrease by 1.
Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/