|
It is currently Sat 23. Nov 2024 10:44:56
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
Martin.S
|
 Posted: Tue 22. Aug 2023 10:03:16 |
|
Joined: Tue 01. Aug 2023 5:48:59
Posts: 4
|
|
got a 100a YPG ESC connected on aux1 on the spirit2
but engine no signal
the FBL is connected with a duo BEC from Mateck systems
6V to the RX end 8.4V for the FBL and servo's all KST
FBL works al servo's working but on aux 1 no signal for the ESC
on the software put the channel mapping to cannel 3 like it is on the TX Frsky X20.
disconnect the red wire from the ESC( power is running on the externe BEC)
some one nows the problen or give me a hint.
regards Martin
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Tue 22. Aug 2023 10:05:28 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello,
please set Channel for Throttle to 1.
I am not sure what is your receiver wiring but in the most cases it is Channel 1 in the Spirit.
You should see throttle channel movement in the software in any case.
_________________
Spirit System developer
|
|
| Top |
|
|
|
Martin.S
|
Posted: Tue 22. Aug 2023 14:43:29 |
|
Joined: Tue 01. Aug 2023 5:48:59
Posts: 4
|
|
reciever is a Jumper R1 sbus 16ch
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 7 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
