|
It is currently Sat 23. Nov 2024 14:13:00
|
View unanswered posts | View active topics
 
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
georgia_hdman
|
 Posted: Mon 26. Nov 2018 15:16:14 |
|
Joined: Mon 12. Nov 2018 19:27:54
Posts: 10
|
|
Hello, I am new to FBL systems and I am new to Spirit Pro.
I am methodically going through the setups with Spirit Pro and my Trex-550 on the workbench.
So far, I have all of the servos moving in the right direction, and the swash plate is leveled.
There is a behavior that I do not understand. Hoping you can help.
When I move the cyclic the swash moves exactly as I expect it to... right, left, forward, aft.
However, when I release the stick to center, the swash does not immediately return to center. It takes a full second or two for the swash to slowly recenter itself.
I am a bit confused by this. Is this normal?
Thanks
Jim
|
|
| Top |
|
 |
|
ZeXx86
|
Posted: Mon 26. Nov 2018 15:22:12 |
|
 |
| Site Admin |
Joined: Mon 29. Apr 2013 16:06:44
Posts: 12442
|
|
Hello Jim,
yes, this behavior is perfectly correct. It is common between FBL units. For beginners it is strange but it is present because model is not moving at all.
While in the air it will move to a desired position so this slow movement will be not there.
_________________
Spirit System developer
|
|
| Top |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
 |
Who is online |
 |
Users browsing this forum: No registered users and 10 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
