Spirit System
https://www.spirit-system.com/phpBB3/

Align BEC RCE-BL60G wiring to Spirit Pro
https://www.spirit-system.com/phpBB3/viewtopic.php?f=35&t=3410
Page 1 of 1

Author:  philipbunce [ Sun 21. Jul 2019 17:05:59 ]
Post subject:  Align BEC RCE-BL60G wiring to Spirit Pro

ESC wiring query on SpiritPro:

I am using the standard Align BEC speed controller (RCE-BL60G) on my Trex 500 but am not sure from the manual the best way to wire this to the Spirit Pro. The manual states that with DSMX satellites (as I am using a DX8 gen2), the throttle is to be connected to the Spirit Pro unit and so am I correct that the wire from the ESC needs to go to the Aux1 unit on my spirit pro

Sorry if this is a dumb questions

Author:  LogoX2 [ Sun 21. Jul 2019 19:56:52 ]
Post subject:  Re: Align BEC RCE-BL60G wiring to Spirit Pro

Yes BEC would get plugged into Aux 1

Author:  philipbunce [ Mon 22. Jul 2019 19:38:48 ]
Post subject:  Re: Align BEC RCE-BL60G wiring to Spirit Pro

thanks for this as make sense.

So when conecting the esc via the Aux1 port and with this being the the standard Align esc, given that I am using the Spektrum AR8010T receiver (connected vi SRXL port) with telem and my Dx8 gen 2 as a receiver, would i still get access to the battery voltage with this wiring or would i only get access to this if i were to use one of the 6 ESCs listed in the manual? thanks

Author:  LogoX2 [ Mon 22. Jul 2019 19:46:21 ]
Post subject:  Re: Align BEC RCE-BL60G wiring to Spirit Pro

Correct that ESC does not support Telemetry.
You could add a Spektrum Flight Pack Voltage sensor.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/