|
It is currently Sun 12. May 2024 18:22:50
|
View unanswered posts | View active topics
Author |
Message |
ZeXx86
|
Posted: Fri 13. Oct 2023 12:03:55 |
|
![Offline Offline](./styles/skymiles_red/imageset/en/icon_user_offline.gif) |
Site Admin |
Joined: Mon 29. Apr 2013 16:06:44 Posts: 12248
|
I now better understand your problem after rereading it.
Overshooting problem might happen when tail center is not optimal. I recommend to enter Subtrim (tuning) menu and verify that servo arm is in the middle as close as possible. If not, use Subtrim CH4 to fix it.
Then make sure that at the same time there is slight angle (3-4°) so that tail slider is closer to the "tail boom". This could already fix the issue. If not, lowering tail end-points (just one that is closer to the boom) little bit can help. Too high angle is not helpful, but too low could cause that tail will loose heading completely when too high torque is applied. So decreasing by step of 10 should be fine. Only decrease until it will be good, not more.
_________________ Spirit System developer
|
|
Top |
|
![](images/spacer.gif) |
zino
|
Posted: Fri 13. Oct 2023 12:10:15 |
|
Joined: Mon 03. Jan 2022 18:08:45 Posts: 59
|
Ok thanks i will check this and if is still problem i will come back. Thanks for your help
|
|
Top |
|
![](images/spacer.gif) |
![](./styles/skymiles_red/theme/images/cellpic4_l.png) |
Who is online |
![](./styles/skymiles_red/theme/images/cellpic4_r.png) |
Users browsing this forum: No registered users and 16 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|