| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Setting for 3 servo Robbe rocking mixer - 4 blade head https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=5636 |
Page 1 of 1 |
| Author: | AdrianR [ Sat 15. Apr 2023 14:31:56 ] |
| Post subject: | Setting for 3 servo Robbe rocking mixer - 4 blade head |
Hi, Could someone please point me in the right direction for the setup of a Robbe / Schluter rocking servo setup? One servo is for the collective, one for the roll, and one for the elevator. The mix is done mechanically. The model was set up with a Futaba CGY750 but the OLED display has failed so I can not read the settings. I will be using a GTR with a Jeti TX. I have tried all the different swashplate types but none seems to suit this type of setup. ------------------------------- So after changing the swash plate to 90deg CCPM and setting the phasing to -45 deg (CCW rotation) the head all seems to move in the correct direction (90deg out of phase for a 4-blade head). Now to continue the setup Please chime in if you have any further information on these setups. Thanks |
|
| Page 1 of 1 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|