It is currently Fri 29. Mar 2024 6:19:36

All times are UTC + 1 hour





Post new topic Reply to topic  [ 3 posts ] 
  Print view Previous topic | Next topic 
Author Message
PostPosted: Sun 20. Sep 2020 10:10:55 
Offline

Joined: Sun 05. Jul 2020 13:57:04
Posts: 6
Dear ALL,

I bought directly after you have launched the SPIRIT RS with the Jeti Receiver included. This week I included the RS into my new Goblin 570 Kraken but I have some serious issues. Yesterday I wanted to do my maiden flight and I have the following issues. It was good that my Heli was on ground and in the pre-flightcheck mode.

Issue 1: If I connect the battery to boot up the FBL there is no sound raised “Receiver connected” like by the normal other Jeti Receivers.If I switch off the transmitter, the Heli goes in Failure safe mode and into the positions I have defined in the FBL Software.  If I switch on the transmitter again the sound is coming,“Receiver connected”Why is this not coming up when booting up the Heli?

Issue 2: It seems that Basic Telemetry data are also not transmitted such as signal strengths like by my other Jeti Receivers? Why is this not transmitted? I thought it was a normal Jeti receiver included.

Issue 3: If I boot up my Heli and build up connection to the battery, sometimes I have the serious behavior that the Heli is not reacting anymore although he was normally booted. It occurs after 1-2 min after booting the FBL.  After FBL Boot up I can move all my sticks for the pre-flight checks, but after a while the Heli goes like in Failure safety mode and is not reacting anymore. I can see that the Heli is still fully powered up and Ic an see that all Servos are fully powered For me, issue 3 is a serious issue.

Have someone faced similar issues?

The entire Heli Setup was quite expensive.

I will not take the risk to fly with all those issues. 

Markus 


Top
 Profile  
 
PostPosted: Sun 20. Sep 2020 13:27:40 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12213
Please disconnect everything from E2 port. Then it will work all OK.

Probably you have some telemetry sensor there. This is wrong with Spirit RS.

_________________
Spirit System developer


Top
 Profile  
 
PostPosted: Mon 21. Sep 2020 17:13:24 
Offline

Joined: Sun 05. Jul 2020 13:57:04
Posts: 6
Hi ALL
Yes thanks. Unfortunately this was the root cause of issue. I connected the Telemetry cable from my YGE Brunchless controller directly with the Port E2.
I have overseen it in the Docu-WIKI that this Channel can not be used.

It seems now its working fine, I'm l'm also getting a sound feedback message that the receiver is connected as expected.


Thanks, Markus


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .