It is currently Sat 24. Aug 2019 20:55:32

All times are UTC + 1 hour





Post new topic Reply to topic  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
PostPosted: Tue 21. May 2019 19:03:12 
Offline

Joined: Mon 08. Apr 2019 21:06:09
Posts: 1
Hello,

I want to use a Hobbywing 120A V4 ESC with a Spirit Pro and a Graupner GR-16 Rx.
The receiver will be connected with SUMD signal cable to the Spirit Pro (RUD).
The HW ESC has two BEC power supply cables.

1. Question:
Can I go with the main ESC signal cable into Spirit Pro (AUX1) and with the slave power supply cable
from the ESC into the Rx, or can this wiring cause electrical failure?

2. Question:
Together with the ESC was supplied a capacitor.
Plug it into the Spirit or the Rx?

Any help is greatly appreciated.


Top
 Profile  
 
PostPosted: Thu 23. May 2019 10:53:50 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 8886
Hello,

1. Prefered way is to plug both cables to the unit.
Or both cables to the receiver. Then two cables should be wired between RX and Spirit unit. But the first option is usually better since all load is plugged in the FBL unit.

2. You can plug it at the CH0 port if it is free. It can help with brownouts during hard maneuvers.

_________________
Spirit System developer


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .