It is currently Fri 29. Mar 2024 0:51:55

All times are UTC + 1 hour





Post new topic Reply to topic  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
 Post subject: Governor with uspirit
PostPosted: Wed 01. May 2019 20:55:28 
Offline

Joined: Mon 08. Apr 2019 6:13:04
Posts: 15
How can I connect the hobbywing platinum esc 25a v4 to my uSpirit?
The esc has a one cable yellow normal servo plug which should be rpm.
With receiver connected and esc (throttle) connected to uspirit I don’t have any jst Adapter left,
. How is this meant to be done?
Thanks
Tom


Top
 Profile  
 
PostPosted: Thu 02. May 2019 2:32:59 
Offline

Joined: Sun 10. Feb 2019 7:10:27
Posts: 74
The yellow wire has to connect to the pitch pin of the P/E/A pins.

You can either get a JST connector and cut it then solder the RPM wire to that wire. -> this is what I did because I did not want a giant mess of wires. Oxy 2 I assume? I had the exact same setup.

Or plug the RPM wire into a JST servo adapter. Make sure it lines up with the Pitch pin.

I had telemetry and ext gov on my Oxy 2. To many wires for very little benefit IMO. The ext gov works but I did not find it any better than the internal gov. I actually preferred the internal gov of the hobbywing. Just my $.02


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .