Spirit System https://www.spirit-system.com/phpBB3/ |
|
Spirit+Castle Phoenix Edge 120HV+Rotor Star RS700 THROTTLE https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2859 |
Page 2 of 2 |
Author: | rfauske [ Mon 08. Oct 2018 9:09:11 ] |
Post subject: | Re: Spirit+Castle Phoenix Edge 120HV+Rotor Star RS700 THROTT |
Have you checked the spirit logs ? And tried to remove the pinion from the main gear so the main and tail is not engaged ? And yes you can not fly it like it is |
Author: | onit12 [ Sat 13. Oct 2018 16:52:14 ] |
Post subject: | Re: Spirit+Castle Phoenix Edge 120HV+Rotor Star RS700 THROTT |
So, one step further or probably not. First @rfauske: Yes, i have removed the pinion from the main gear, and there first test runs were ok, but difficult is, that the problem occurs from time to time, not always.... so this is not really meaningful. I have installed the antistatic kit from logo and tried some test runs. Motor RPM stills goes down from time to time. The spirit unit isn`t rebooting any more when the RPM goes to zero, but basic problem is still the same. I have tried with firmware version 2.4.3, here are the errors in the spirit log: 00:00 Calibration Finished 00:10 Good Health Message 00:20 Good Health Message 00:30 Received Frame was Corrupted 00:40 Good Health Message 00:50 Good Health Message 01:00 Good Health Message 01:10 Governor was Engaged 01:20 Good Health Message 01:30 Good Health Message 01:40 Governor was Engaged RPM Sensor data are too noisy 01:50 Good Health Message 02:00 Good Health Message and with the newest firmware 2.5.2: 00:00 Calibration Finished 00:10 Good Health Message 00:20 Good Health Message 00:30 Governor was Engaged RPM Sensor data are too noisy 00:40 Good Health Message Still any suggestions, because I am clueless now Tino |
Author: | rfauske [ Sat 13. Oct 2018 16:55:52 ] |
Post subject: | Re: Spirit+Castle Phoenix Edge 120HV+Rotor Star RS700 THROTT |
Tried without gov in the spirit and in the scorpion instead ? |
Author: | ZeXx86 [ Sat 13. Oct 2018 18:14:45 ] |
Post subject: | Re: Spirit+Castle Phoenix Edge 120HV+Rotor Star RS700 THROTT |
Hello, unfortunately antistatic spray might not help if static discharges are really big. It look like also receiver signal is corrupted from time to time. Oh, you have connected RPM sensor. Can you tell me which sensor you are using? I guess it is RPM cable from Castle ESC, right? I recommend to disconnect this cable and try again. But with Castle governor or at least throttle curves. If the RPM cable is feeding bad signal then it could cause big troubles. |
Page 2 of 2 | All times are UTC + 1 hour |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |