Spirit System
https://www.spirit-system.com/phpBB3/

Spirit Geo-Link Connection
https://www.spirit-system.com/phpBB3/viewtopic.php?f=20&t=2695
Page 1 of 1

Author:  Jeeprogue [ Tue 07. Aug 2018 15:41:26 ]
Post subject:  Spirit Geo-Link Connection

I have a Spirit Pro and i am currently using an AR4649T with a Satellite and the Uni-Cable for HobbyWing Telemetry. My Geo-link arrives tomorrow and in the manual it specifies that the Geo-Link uses the Secondary Satellite port on the Spirit Pro, the Uni Cable for HobbyWing Telemetry uses the Primary Satellite Port. Is it possible to use a Y harness on one of the 2 satellite ports to and use the Telemetry, Geo-Link, and Satellite RX, or will i have to remove either the Satellite or Telemetry?

Author:  rediary [ Tue 07. Aug 2018 18:33:46 ]
Post subject:  Re: Spirit Geo-Link Connection

+1

Also very interested in how this will work!

Author:  LogoX2 [ Tue 07. Aug 2018 19:10:43 ]
Post subject:  Re: Spirit Geo-Link Connection

Use a Spektrum V2 adapter to plug the Sat into the Rud port.
You can use a Y cable to apply power to the 4649T or power it
using the Aux 2 port.

Author:  Jeeprogue [ Wed 08. Aug 2018 0:06:08 ]
Post subject:  Re: Spirit Geo-Link Connection

i was scrolling through some of the other posts here, i came across this thread viewtopic.php?f=20&t=2677 discussing setup using a Satellite RX and the Geo-Link on the regular Spirit, ZeXx86 specifies that on the regular spirit with only 1 port, a Y-harness can be used for the Geo-Link and Satellite RX. one would assume this means the same would work with the Spirit Pro?

Author:  rediary [ Wed 08. Aug 2018 18:31:20 ]
Post subject:  Re: Spirit Geo-Link Connection

Would something like this work providing power to two accessories from a single sat port?

https://www.amainhobbies.com/spektrum-rc-3-yharness-jst-ultra-lightweight-spmyhjst3ul/p21849?gclid=CjwKCAjwqarbBRBtEiwArlfEIAPl2Mid11hTVhOuOL7XpKdHIGsGZJvb9yDoTeZWcNA4Uc70arZN3hoCo1QQAvD_BwE

Author:  LogoX2 [ Wed 08. Aug 2018 19:52:23 ]
Post subject:  Re: Spirit Geo-Link Connection

No you can NOT use a Y cable on the Geo Link.
It must be used by itself on the Sat port.

Author:  ZeXx86 [ Sat 11. Aug 2018 13:07:23 ]
Post subject:  Re: Spirit Geo-Link Connection

Here is how you can connect 3x Spektrum satellites and 1x SPM4649T together with Spirit Pro.
You can also connect 4th Spektrum satellite instead of SPM4649T - it is only necessary to modify Spektrum adapter so that signal wire is separately connected at the AIL pin.

Attachments:
4xSpektrum.jpg
4xSpektrum.jpg [ 659.98 KiB | Viewed 463 times ]

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/