It is currently Thu 28. Mar 2024 10:27:54

All times are UTC + 1 hour





Post new topic Reply to topic  [ 6 posts ] 
  Print view Previous topic | Next topic 
Author Message
 Post subject: Heli is not responding
PostPosted: Thu 26. Sep 2019 2:45:15 
Offline

Joined: Fri 13. Sep 2019 1:20:17
Posts: 21
When my 360 was stock, everything worked
When I dove into setting up a Spirit on this helo, some things worked, including throttle/CP
Now, I’ve copied and downloaded an RC Grouper's Spirit file and Spek file, and now no thr/CP or cyclic

On my Spek's monitor, thr/CP are sending the signal as well as cyclic, so it must be something on the Spirit's end or??? Also, it’s bound.

Can anyone give me a place to start looking pls?


Top
 Profile  
 
PostPosted: Thu 26. Sep 2019 2:46:05 
Offline

Joined: Fri 13. Sep 2019 1:20:17
Posts: 21
Heli is getting power, is bound, in my hand is responding as far as the gyro goes (swash and rudder servo)

Tx is sending signals to all servos

Heli just doesn’t seem to initialize, doesn’t throttle, servos don’t respond (when I give stock input)


Top
 Profile  
 
PostPosted: Thu 26. Sep 2019 12:24:39 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12210
Hello,

can you verify if Status LED is displaying any activity upon powering?

It should pulsate slowly and then stay On after initialization.

_________________
Spirit System developer


Top
 Profile  
 
PostPosted: Thu 26. Sep 2019 20:01:07 
Offline

Joined: Fri 13. Sep 2019 1:20:17
Posts: 21
Yes, it does a very slow pulse, and stays on and the swash dances a little.

But no stick input


Top
 Profile  
 
PostPosted: Thu 26. Sep 2019 21:07:01 
Offline
Site Admin

Joined: Mon 29. Apr 2013 16:06:44
Posts: 12210
Then the problem is just in a wrong Receiver type settings.

Sadly you have not stated what receiver or radio you are using, so it is hard to help more.

Can you verify that when you will open the General tab there is receiver type that you are using right after initialization?

_________________
Spirit System developer


Top
 Profile  
 
PostPosted: Sat 28. Sep 2019 3:06:56 
Offline

Joined: Fri 13. Sep 2019 1:20:17
Posts: 21
Sorry for my minimal info

Good news, I figured it out.

My friend's settings I used included a GEOLINK. I’m not using a GEOLINK, so I just needed to un deselect that box.

Finished setup today, performed hover check, ALL GOOD!!!

Thx!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  



Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
skymiles_red v1.0.1 designed by Team -Programming forum-سيارات للبيع .