The Rudder Gain was already at 5% have it set to 0
And Revomix was already at 4 I changed to 3
No difference
| Spirit System https://www.spirit-system.com/phpBB3/ |
|
| Trex 150 https://www.spirit-system.com/phpBB3/viewtopic.php?f=17&t=3609 |
Page 1 of 2 |
| Author: | tomsl [ Sat 19. Oct 2019 18:50:27 ] |
| Post subject: | Trex 150 |
Hi I converted a Trex 150 to a μSpirit. I am very happy with it I can adjust everything with my DS 16 only my tail rotor swings but not always only sometimes. can someone share settings with me? Thomas |
|
| Author: | tomsl [ Sun 20. Oct 2019 22:29:36 ] |
| Post subject: | Re: Trex 150 |
is there anybody who can help ???? Do this or that .... |
|
| Author: | ZeXx86 [ Mon 21. Oct 2019 10:01:14 ] |
| Post subject: | Re: Trex 150 |
Yes, but you are asking for somebody with T-Rex 150. We have no T-Rex 150, but to resolve tail issues you have to change Advanced/Pirouette Consistency parameter. |
|
| Author: | tomsl [ Mon 21. Oct 2019 16:37:52 ] |
| Post subject: | Re: Trex 150 |
Thank you! I will test later |
|
| Author: | tomsl [ Mon 21. Oct 2019 16:48:40 ] |
| Post subject: | Re: Trex 150 |
I'm already at the value of 130 I can not go lower When I put it up, it starts to swing heavily Is there still a possibility? Thank you for your help |
|
| Author: | ZeXx86 [ Tue 22. Oct 2019 12:29:52 ] |
| Post subject: | Re: Trex 150 |
Yes, you can change Rudder Delay. First try to set 0. Then try to set 25. Probably increasing Rudder frequency to a higher can help a lot too. |
|
| Author: | tomsl [ Tue 22. Oct 2019 18:45:52 ] |
| Post subject: | Re: Trex 150 |
between 0 and 30 no differences |
|
| Author: | ZeXx86 [ Wed 23. Oct 2019 8:50:58 ] |
| Post subject: | Re: Trex 150 |
In this case please decrease Gyro Gain until there are no oscillations and set Advanced/Rudder Revomix to 3-4. This might help a lot. |
|
| Author: | tomsl [ Thu 24. Oct 2019 4:20:48 ] |
| Post subject: | Re: Trex 150 |
The Rudder Gain was already at 5% have it set to 0 And Revomix was already at 4 I changed to 3 No difference
|
|
| Author: | ZeXx86 [ Fri 25. Oct 2019 11:18:34 ] |
| Post subject: | Re: Trex 150 |
This is very low value. What will happen if you will set Gyro Gain to 40%? We can prepare special firmware where Pirouette Consistency can have half effect. Hopefully it will help. |
|
| Page 1 of 2 | All times are UTC + 1 hour |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|