Spirit System
http://spirit-system.com/phpBB3/

Rudder Gyro Gain Spektrum DX18QQ transmitter
http://spirit-system.com/phpBB3/viewtopic.php?f=17&t=3001
Page 1 of 1

Author:  georgia_hdman [ Thu 29. Nov 2018 17:30:16 ]
Post subject:  Rudder Gyro Gain Spektrum DX18QQ transmitter

Hi again,

SPirit manual says:

Rudder Common Gain – 1.00x means no multiplication. This is the recommended value for
550-class helicopters and smaller. For bigger helicopters it is often higher. 1.3x could be fine.
Gyro Gain in your transmitter should be configured to approximately 50% for the first flight.

In my Spektrum DX18QQ transmitter, I have heading-lock assigned to Gear Channel and assigned to switch A.

Position 0 on the switch is set to Heading Lock; position 1 is set to Rate Mode -- and I see this in the diagnostics tab on the spirit software. I have also verified that in heading lock mode that the tail rotor move correctly when I move the tail on the workbench.

Both position 1 and position in the transmitter are set at 0.0%.

Is this where I would set the transmitter gain to 50% (according to the spirit manual) for first flight? Would I set to 50% for both position 1 and position 0?

Thanks
Jim

Attachments:
IMG_0583.jpg
IMG_0583.jpg [ 80.65 KiB | Viewed 207 times ]

Author:  ZeXx86 [ Thu 29. Nov 2018 22:02:55 ]
Post subject:  Re: Rudder Gyro Gain Spektrum DX18QQ transmitter

Hello,

yes, you are right. You can set for example 40% for position 0 and 50% for position 1.
For the maiden flight you can start with 40% and then try higher gain quickly just by switching the switch A.

Page 1 of 1 All times are UTC + 1 hour
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/